Mocom HD/3D Projection Screen
Solstice™ Essen PROJECTION SCREEN
2D /HD, Passive / Active 3D Ready projection screen !
- Solstice™ Cost-effective version : 82″ One size
- Ultra-High Gain Front Projection Screen
- HD/UHD Resolution capable
- Outstanding Color Accuracy
- Rich gradation
- High Uniformity with no hot spotting
- Fast response time
- Micro-fine diffusion lines along the scanning axis and micron sized AL particles
- High polarization retention
- Phenomenal 3D imaging and image depth
Model : S3D-82
- Excellent for any application
- Front projection screen / Rigid Screen
- Gain : 18
- Surface : Aluminum
- Brightness Uniformity : Over 80% without hot spots
- 82″ One size
- Ratio : 16:9 (HD)
- Frame Material : Black silicon plastic (Thickness : 45mm)
|Overall Dimensions||( Including Frame)|
|Optimal Projection Distance||m||3.7|
Q : What are the key differences between Mocom's front-projection screens and conventional front-projection screens?
Traditional paper and glass-bead screens are only primarily more suitable than Mocom screens in where the screens need to be rolled up (Mocom 18-23gain front-projection screens are solid lenses, so they cannot be rolled up.
This performance benefits of Mocom screens will enable customers to place Mocom’s 18/23-gain screens into situations that previously would have required either rear-projection or video (e.g. plasma) displays. Mocom screens far outperform rear-projection or plasma displays. In addition, they provide far lower maintenance costs.
A : Mocom concaved front projection screens have an ultra-fine grain which can pick up figerprint and dust. They can be cleaned using lint free cloth. In addition, you can use a hair dryer on COOL air to clean out the dust.
A : However, we do not recommend that you to use them it applications where the sunlight will be at the same angle as the projector light source for obvious reasons or in wet or windy condition. The off-axis ambient light rejection of these screens is astonishingly high, allowing them to be used as billboards under full vapor lighting in trade shows and other public facilities.
A : It’s all depending on your needs. Bigger screen or brighter images will require higher lumens. We do not recommend short throw projectors because the curvature of the screen is calculated using a normal projector’s throw distance. For short throw projector’s, the curvature of the screen has to be calculated differently, so please check with us for more information if you need to use a short throw projector.
A :In general the best viewing position is behind the projector. The optimal viewing position is equal to or further away from the screen than the center of the sphere represented by the screen’s curvature. For the larger Mocom screens, the center of the sphere is approximately 19.5 feet from the face of the screen. However, a large number of our screens in use are actively viewed at shorter distances and still achieve very satisfactory results. Please be aware that as you get close to the screen, limitations in the projector such as– pixelation, etc. — become visible due to the sharpness of Mocom screens.)
A : Screens below 150″ come with a fiberglass back-bracket that has two vertical rows of threaded studs set approximately 6″ above the centerline of the screen. These can be mounted on hooks which will allow the screen to be swung into the correct angle for viewing.
※ Please refer to the “ Mocom Screen Assembly & Installation guide ”
A : It’s easy. Start by adjusting the vertical angle of the screen so that the center of the screen is exactly perpendicular to the line drawn from the light source (projector).
Then, adjust the vertical angle for the highest brightness when observed from the main viewing positions.
※ Please refer to the “ Mocom concaved Screen Assembly & Installation guide ”